CLOSEOUT -- ONE LEFT

IC-703 is Icom's product for the QRP enthusiasts. Focusing on QRP performance rather than an all-in-one solution, the IC-703 covers the Amateur Bands 160m to 6m*. Depending on the power supply the rig is capable of 5W @ 9.6VDC and 10W @ 13.8VDC, plus it has an internal antenna tuner. Icom engineers have addressed a lot of the concerns about current consumption and other comments gathered over the past two years regarding QRP performance. While it looks and feels like the IC-706MKIIG, this rig is a QRP version, not a replacement.

SPECIFICATIONS

GENERAL
Frequency Range	: 1.80~1.99 3.50~3.99, 7.00~7.30, 10.10~10.15, 14.00~14.35, 18.068~18.168, 21.00~21.45, 24.89~24.99, 28.00~29.70
Mode	: USB/LSB/CW/RTTY/AM/FM
Temperature range	: -10°C to +60°C; +14°F to +140°F
Antenna Impedance	: 50 ohms(SO-239)
Frequency stability	: Less than ±0.5 ppm (0 to 50°C; +32 to +122°F)
No. of Memory Ch.	: 105(99 split, 6 scan edges)
Frequency stability	: Less than ±0.5 ppm (1 min. after powered ON/0 to 50°C; +32 to +122°F)
Power supply voltage	: 9.0 to 15.87 V DC (negative ground)
Current Drain	: Tx   Rx   10 W     5 W   Standby   Max. audio   3.0 A   2.0 A(9.6V)   0.25 A (typ.)   0.45 A (typ.)
Dimensions  (projections not included)	: 167(W) × 58(H) × 200(D) mm;   6 9/16(W) × 2 9/32(H) × 4 7/8(D) in
Weight (approx.)	: 2.0 kg; 4 13/32 lb
TRANSMITTER
Mode	USB/LSB/CW/RTTY/AM/FM
Modulation system	: USB/LSB    Blanced Modulation   AM      Low Level Modulation   FM      Variable Reactance Frequency Modulation
Spurious emission	: 50 dB (HF bands)
Carrier suppression	: More than 40 dB
Unwanted sideband suppression	: More than 50 dB
Spurious Emissions	: Below 30 MHz: Less than -50 dB  Above 50 MHz: Less than -60 dB
Microphone Connector	: 8-pin modular jack (600 ohms)
Output Power	:USB/LSB/CW/FM/RTTY  0.1 to 10 W (at 13.8V)    AM                              0.1 to 4 W (at 13.8 V)  USB/LSB/CW/FM/RTTY   0.1 to 5 W (at 9.6V)    AM                               0.1 to 2 W (at 9.6 V)
RECEIVER
Receive system	: Double conversion Superheterodyne system
Intermediate frequencies	: 1st 64.455 MHz (for all modes)   2nd 455 kHz (for all modes)
Sensitivity (typical)	:  Frequency Range (MHz) SSB, CW, RTTY (at 2.4 kHz BW) AM (at 6 kHz BW) FM (at 15 kHz BW) 0.50 - 1.799 __ 13µV*1 __ 1.80 - 29.99 0.16µV *1 2µV *1 __ 28.0 - 29.7 0.16µV *1 2µV *1 0.5µV *1 10 dB S/N for SSB, CW, RTTY and AM, 12 dB SINAD for FM *1 Pre-amp is ON
Squelch sensitivity  (Pre-amp: ON)	: SSB, CW, RTTY   FM   Less than 5.6 µV   Less than 0.32 µV
Selectivity  (typical)	: SSB/ CW (BW: 2.4 kHz)      AM /FN-N (BW: 6 kHz)   FM (BW: 15 kHz)   More than 2.4 kHz/-6dB   Less than 4.5 kHz/-60 dB   More than 8.0 kHz/-6dB   Less than 30.0 kHz/-60 dB   More than 12.0 kHz/-6 dB   Less than 30.0 kHz/-60 dB
Spurious Response	: More than 70 dB
AF output power	: More than 1.0 W  with an 8 ohms load
RIT variable range	: ±9.99 kHz

All stated specifications are subject to change without notice or obligation.